LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2000 >> Impala V6-3.8L VIN K >> Repair and Diagnosis >> Heating and Air Conditioning >> Air Door >> Air Door Actuator / Motor >> Service and Repair >> Mode Actuator Replacement

Mode Actuator Replacement

REMOVAL PROCEDURE




1. Remove the left instrument panel insulator.
2. Remove the instrument panel driver knee bolster.
3. Cut the tie strap (1) on the back side of the mode valve vacuum actuator.




4. Remove the vacuum lines from the mode valve vacuum actuator.
5. Carefully rotate the mode vacuum actuator towards the front of the vehicle until the actuator is released from the mounting pins on the HVAC module.




6. Disconnect the vacuum actuator pushrod from the mode valve lever and remove the actuator.

INSTALLATION PROCEDURE




1. Connect the vacuum actuator push rod from the mode valve lever and position the actuator.




2. Carefully rotate the mode vacuum actuator towards the rear of the vehicle until the actuator is engaged on the mounting pins on the HVAC module.




3. Install the instrument panel driver knee bolster.
4. Install the left side instrument panel insulator.
scientia non olet · About LEMON Manuals