Muffler Replacement (Dual - Left Side)

Removal Procedure





1. Raise and suitably support the vehicle. Refer to Vehicle Lifting.

Notice: Refer to Catalytic Converter Movement Notice in Service Precautions.

2. Suitably support the exhaust system.

Important: The cut(s) must be made on the straight pipe closest to the curve coming out of the left-side exhaust muffler (2). Do not cut on the curve or bend.

3. Cut the exhaust pipe closest to the left-hand exhaust muffler bend (1).





4. Disconnect the exhaust muffler rear hanger insulators from the exhaust muffler.
5. Remove the exhaust muffler.

Installation Procedure





1. Install the exhaust muffler.
2. Connect the exhaust muffler rear hanger insulators to the exhaust muffler.

Notice: Refer to Fastener Notice in Service Precautions.





3. Install the exhaust muffler to the exhaust pipe.
Tighten the exhaust muffler inlet pipe clamp nuts to 50 Nm (37 ft. lbs.).
4. Inspect the exhaust system for leaks and underbody contact.
5. Remove the support from the exhaust system.
6. Lower the vehicle.