Engine Mount Strut Bracket Replacement (Upper Radiator Support)

Removal Procedure





1. Remove the engine mount strut(s) from the engine mount strut bracket(s) at the upper radiator support. Refer to Engine Mount Strut Replacement (Left) and/or Engine Mount Strut Replacement (Right).





2. Remove the four bolts from the engine mount strut bracket to the upper radiator support.
3. Remove the engine mount strut bracket from the upper radiator support.

Installation Procedure





1. Position the engine mount strut bracket over the upper radiator support so the engine mount strut bracket and the engine mount strut are aligned. Align the engine mount strut bracket with the proper holes of the upper radiator support.

Notice: Refer to Fastener Notice in Service Precautions.

2. Install the four bolts through the engine mount strut bracket to the upper radiator support.
Tighten the engine mount strut bracket bolts at the upper radiator support to 28 Nm (21 ft. lbs.).





3. Install the engine mount strut(s) to the engine mount strut bracket(s) at the upper radiator support. Refer to Engine Mount Strut Replacement (Left) and/or Engine Mount Strut Replacement (Right).

Oil Level Indicator and Tube Replacement

Removal Procedure





1. Remove the oil level indicator.
2. Loosen the nut holding the oil level indicator tube bracket to the exhaust manifold stud.
3. Remove the oil level indicator tube. Pull upward.


Installation Procedure





1. Install the oil indicator tube to the engine. Make sure that the 0-ring is in place. Make sure that the oil level indicator tube is fully seated in the engine.
2. Slide the oil indicator tube bracket onto the exhaust manifold stud.

Notice: Refer to Fastener Notice in Service Precautions.

3. Install the oil level indicator tube bracket nut on the exhaust manifold stud.
Tighten the oil level indicator tube bracket nut to 19 Nm (14 ft. lbs.).
4. Install the oil level indicator.