Engine Mount Strut Bracket Replacement (Right Upper)

Removal Procedure





1. Disconnect the battery ground (negative) cable. Refer to Battery Negative Cable Disconnect/Connect Procedure in Starting and Charging.
2. Remove the right engine mount strut at the upper engine mount strut bracket. Refer to Engine Mount Strut Replacement (Left) or Engine Mount Strut Replacement (Right).





3. Loosen the lower engine mount strut bracket nut.
4. Remove the lower engine mount strut bracket bolts.
5. Remove the fuel injector sight shield. Refer to Fuel Injector Sight Shield Replacement.
6. Remove the EVAP emissions canister purge valve. Refer to EVAP Canister Purge Valve Replacement in Computers and Controls.





7. Remove the upper engine mount strut bracket bolts.
8. Remove the upper engine mount strut bracket.

Installation Procedure





1. Install the upper engine mount strut bracket.

Notice: Refer to Fastener Notice in Service Precautions.

2. Install the upper engine mount strut bracket bolts.
Tighten the upper engine mount strut bracket bolts to 50 Nm (37 ft. lbs.).
3. Install the EVAP emissions canister purge valve. Refer to EVAP Canister Purge Valve Replacement in Computers and Controls.
4. Install the fuel injector sight shield. Refer to Fuel Injector Sight Shield Replacement.





5. Install the lower engine mount strut bracket bolts.
- Tighten the lower engine mount strut bracket nut.
Tighten
Tighten the lower engine mount strut bracket nut to 30 Nm (22 ft. lbs.).
- Tighten the lower engine mount strut bracket bolts.
Tighten
Tighten the lower engine mount strut bracket bolts to 50 Nm (37 ft. lbs.).





6. Install the right engine mount strut at the upper engine mount strut bracket. Refer to Engine Mount Strut Replacement (Left) or Engine Mount Strut Replacement (Right).
7. Connect the battery ground (negative) cable. Refer to Battery Negative Cable Disconnect/Connect Procedure in Starting and Charging.