Park Brake Cable Replacement (Left/Right Rear)

Removal Procedure





1. Raise and suitably support the vehicle. Refer to Vehicle Lifting.
2. Loosen the brake cable at the equalizer (2) and separate.





3. Remove the parking brake equalizer.
4. Remove the cable from the mounting bracket.
5. Remove the cable from the actuator lever.
6. Remove the parking brake cable from the vehicle.

Installation Procedure





1. Place the cable in position.
2. Install the cable on the actuator lever.
3. Install the cable on the mounting bracket.
4. Install the retaining pin.





5. Tighten the nut on the equalizer (2) in order to remove the slack in the cable.
6. Lower the vehicle.
7. Adjust the parking brake. Refer to Park Brake Cable Service/Adjustment.