Brake Modulator Bracket Replacement

Removal Procedure





1. Turn the Ignition switch to the OFF position.
2. Remove the two BPMV mounting bracket nuts (3) and one bolt located near the bottom and one nut (1) located at the top of the BPMV mounting bracket (4) to the strut tower.
3. Disconnect the ground strap between the EBCM assembly and the chassis.
4. Remove the BPMV mounting bracket (4) from the vehicle.
5. Remove BPMV and EBCM assembly (2) from the BPMV mounting bracket (4).

Installation Procedure





1. Install the BPMV and EBCM assembly (2) to the BPMV mounting bracket (4).
2. Install the BPMV bracket (4) to the strut tower.

Notice: Refer to Fastener Notice in Service Precautions.

3. Install the one bolt and three nuts that attach the BPMV mounting bracket (4) to the strut tower.
^ Tighten the lower two BPMV mounting bracket nuts (3) and bolt to 10 Nm (89 inch lbs.).
^ Tighten the top nut (1) for BPMV mounting bracket (4) to strut tower to 3 Nm (27 inch lbs.).
4. Reconnect the ground strap between the EBCM assembly and the chassis.
5. Turn the ignition switch to the RUN position, engine off.
6. Perform the A Diagnostic System Check - ABS.