Brake Pedal Replacement

Removal Procedure





1. Remove the left instrument panel insulator.
2. Uncap the BCM and position aside.
3. Remove the stoplamp switch. Refer to Stoplamp Switch Replacement
4. Remove the cruise release switch (if equipped). Refer to Cruise Release Switch Replacement.
5. Remove the wiring harness clips
6. Remove the brake pedal pushrod retaining clip.
7. Remove the brake pedal pushrod and washer.
8. Inspect all parts for evidence of wear. Repair or replace the worn parts as needed.





9. Remove the brake pedal bolt and nut.
10. Remove the brake pedal and bushings.

Installation Procedure





1. Install the brake pedal and the bushings.

Notice: Refer to Fastener Notice in Service Precautions.

2. Install the brake pedal bolt and nut.
^ Tighten the bolts to 40 Nm (30 ft. lbs.).





3. Install the brake pedal washer and pushrod.
4. Install the brake pedal pushrod retaining clip.
5. Install the wiring harness clips
6. Install the cruise release switch (if equipped). Refer to Cruise Release Switch Replacement.
7. Install the stoplamp switch. Refer to Stoplamp Switch Replacement.
8. Position and clip the BCM back into place.
9. Install the left instrument panel insulator.