Rear Side Door Window Outer Sealing Strip Replacement

Rear Side Door Window Outer Sealing Strip Replacement (Impala)

Removal Procedure




1. Position the rear window all the way down.
2. Remove the rear door trim panel to have access to these screws. Refer to Rear Side Door Trim Panel Replacement Service and Repair




3. Remove the rear door outer belt sealing strip screws.




4. Remove the rear window outer belt sealing strip by pulling the sealing strip from the rear door pinch-weld flange.

Installation Procedure




1. Position the rear door outer belt sealing strip to the rear door pinch-weld flange.




2. Install the rear door outer belt sealing strip to the pinch-weld flange, pressing into place until full seated.

Notice: Refer to Fastener Notice in Cautions and Notices.




3. Install the rear door outer belt sealing strip screws.

Tighten the rear door outer belt sealing strip screws to 2 Nm (18 lb in).

4. Install Rear door trim panel. Refer to Rear Side Door Trim Panel Replacement Service and Repair