Sunshade Glass Panel Replacement

REMOVAL PROCEDURE




1. Position the sunroof sunshade to the full rearward position.
2. Remove the screws from the sunroof glass panel.




3. Lift the sunroof glass panel from the sunroof module to remove it.

INSTALLATION PROCEDURE

IMPORTANT: Ensure that the information logo stencil on the sunroof glass panel is at the rear of the opening.




1. Position the sunroof glass panel into the sunroof module.

NOTE: Refer to Fastener Notice in Service Precautions.




2. Install the sunroof glass panel screws.

Tighten
Tighten the sunroof glass panel screws to 4 N.m (35 lb in).

3. Adjust the sunroof glass panel. Refer to Sunroof Glass Height and Opening Fit Adjustment.
4. Inspect the sunroof glass panel for proper operation.
5. Reposition the sunroof sunshade to the original position.