Sunroof Sunshade Replacement (First Design)

Sunroof Sunshade Replacement (First Design)

Removal Procedure




1. Remove the sunroof glass panel. Refer to Sunroof Glass Panel Replacement.
2. Position the sunshade to the closed position.
3. Remove the rear half of the sunshade by bowing the sunshade in the center and pushing the sunshade to 1 side in order to allow the opposite side of the sunshade to be lifted out of the sunshade channel.




4. Remove the rear half of the sunshade from the sunroof module.




5. Position the front half of the sunshade rearward.
6. Remove the front half of the sunshade by bowing the sunshade in the center then pushing the sunshade to 1 side in order to allow the opposite side of the sunshade to be lifted out of the sunshade channel.




7. Remove the front half of the sunshade from the sunroof module.

Installation Procedure




1. Position the front sunshade to the sunroof module.
2. Insert 1 side of the front sunshade into the sunshade channel.




3. Bow the center of the front sunshade upwards in order to allow the opposite side to drop into the sunshade channel.
4. Slide the front sunshade forward.




5. Insert one side of the rear sunshade into the sunshade channel.




6. Position the tab on the rear sunshade to the center recessed area of the front sunshade and into the sunshade channel




7. Bow the center of the rear sunshade upwards in order to allow the opposite side to drop into the sunshade channel.
8. Inspect the sunshade for proper operation.
9. Install the sunroof window. Refer to Sunroof Glass Panel Replacement.