Rear Bumper Fascia Splash Shield Replacement

Rear Bumper Fascia Splash Shield Replacement

Tools Required

J 38778 Door Trim Pad Clip Remover

Removal Procedure




1. Drill out the plastic rivet from the rear fascia extension corner if equipped.
2. Remove the rear bumper fascia extension screw if equipped.




3. Remove the rear bumper fascia splash shield nuts.




4. Remove the rear bumper fascia splash shield bolt.




5. Remove the rear bumper fascia push-in retainer using J 38778 .




6. Remove the rear bumper fascia splash shield screws.
7. Remove the rear bumper fascia splash shield.

Installation Procedure




1. Install the rear bumper fascia splash shield over the studs.

Notice: Refer to Fastener Notice in Cautions and Notices.

2. Install the rear bumper fascia splash shield nuts.

Tighten the rear bumper fascia splash shield nuts to 2 Nm (18 lb in).




3. Install the rear bumper fascia splash shield bolt.

Tighten the rear bumper fascia splash shield bolts to 2 Nm (18 lb in).




4. Install the rear bumper fascia splash shield screws.

Tighten the rear bumper fascia splash shield nut to 2 Nm (18 lb in).




5. Install the rear bumper fascia splash shield push-in retainers.




6. Using a new plastic rivet,install the plastic rivet to the rear fascia extension corner to splash shield if equipped.
7. Install the rear bumper fascia extension screw to the rear fascia extension corner to splash shield if equipped.

Tighten the rear bumper fascia extension screw to 2 Nm (18 lb in).