Rear Bumper Fascia Extension Replacement

Rear Bumper Fascia Extension Replacement

Removal Procedure

1. Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle in General Information.
2. Remove the rear tires and wheels. Refer to Tire and Wheel Removal and Installation in Tires and Wheels.




3. Drill out the plastic rivet from the rear fascia extension corner to the splash shield.
4. Remove the rear bumper fascia extension screw from the rear fascia extension corner to the splash shield.




5. Remove the rear bumper fascia extension lower screw from the lower rear fascia to splash shield.




6. Drill out the rivets from the lower rear end of the rear fascia extension.




7. Remove the spring clips from the fascia extension.




8. Remove the fascia extension.

Installation Procedure




1. Install the fascia extension onto the fascia.




2. Install the spring clips through the tabs in the fascia extension.




3. Using new plastic rivets, install the plastic rivets to the lower rear end of the rear fascia extension.

Notice: Refer to Fastener Notice in Cautions and Notices.




4. Install the rear bumper fascia extension lower screw to the lower rear fascia and splash shield.

Tighten the rear bumper fascia extension lower screw to 2 Nm (18 lb in).




5. Using a new plastic rivet, install the plastic rivet to the rear fascia extension corner to the splash shield.
6. Install the rear bumper fascia extension screw to the rear fascia extension corner to the splash shield.

Tighten the rear bumper fascia extension screw to 2 Nm (18 lb in).

7. Install the rear wheels and tires. Refer to Tire and Wheel Removal and Installation in Tires and Wheels.
8. Lower the vehicle.