Front Upper Fascia Support Bracket Replacement

Front Upper Fascia Support Bracket Replacement

Removal Procedure




1. Open the hood.
2. Remove the upper radiator air baffle. Refer to Radiator Air Baffle Assemblies and Deflectors (Upper) Radiator Air Baffle Assemblies and Deflectors (Side) Radiator Air Baffle Assemblies and Deflectors (Lower) in Engine Cooling.
3. Remove the bolts from the front bumper fascia center support bracket.
4. Remove the front bumper fascia center support bracket from the hood latch center support.

Installation Procedure




1. Align the front bumper fascia center support bracket to the hood latch center support and the front bumper fascia upper support.
2. Install the bolts to the hood latch center support and hand tighten.

Notice: Refer to Fastener Notice in Cautions and Notices.

3. Install the bolt to the front bumper fascia upper support.

Tighten the bolt to the front bumper fascia upper support to 10 Nm (89 lb in).

4. Tighten the bolts to the hood latch center support.

Tighten the bolts to the hood latch center support to 10 Nm (89 lb in).

5. Install the upper radiator air baffle. Refer to Radiator Air Baffle Assemblies and Deflectors (Upper) Radiator Air Baffle Assemblies and Deflectors (Side) Radiator Air Baffle Assemblies and Deflectors (Lower) in Engine Cooling.
6. Close the hood.