Front Bumper Fascia Lower Support Replacement

Front Bumper Fascia Lower Support Replacement (Impala)

Tools Required

J 38778 Door Trim Pad Clip Remover

Removal Procedure




1. Remove the screws from the lower front bumper fascia.




2. Remove the push-in retainers from the front bumper fascia lower support at the front bumper impact bar using J 38778 .
3. Remove the front bumper fascia lower support from the front bumper fascia and front bumper impact bar.

Installation Procedure




1. Install the front bumper fascia lower support to the front bumper impact bar.
2. Install the push-in the retainers to the front bumper fascia lower support at the front of the bumper impact bar.

Notice: Refer to Fastener Notice in Cautions and Notices.




3. Install the screws to the lower front bumper fascia.

Tighten the screws to the lower front bumper fascia to 2 Nm (18 lb in).