Front Bumper Fascia Extension Replacement

Front Bumper Fascia Extension Replacement

Removal Procedure

1. Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle in General Information.




2. Drill out the plastic rivets from the front bumper fascia extension corner to the front fender liner.
3. Remove the lower fascia support. Refer to Front Bumper Fascia Lower Support Replacement (Impala) (Front Bumper Fascia Lower Support Replacement)Front Bumper Fascia Lower Support Replacement (Monte Carlo) (Front Bumper Fascia Lower Support Replacement) in Bumpers.




4. Remove the front fender liner to front bumper fascia screws.




5. Remove the spring clips from the fascia extension.




6. Remove the fascia extension.

Installation Procedure




1. Position the fascia extension to the fascia.




2. Install the spring clips starting at the center of the fascia extension and working outward.





Notice: Refer to Fastener Notice in Cautions and Notices.

3. Install the screws to the front fender liner at the front of the front bumper fascia.

Tighten the front fender liner to fascia screws to 2 Nm (18 lb in).




4. Using new plastic rivets, install the 2 plastic rivets to the front bumper fascia extension corner and front fender liner.
5. Install the lower fascia support. Refer to Front Bumper Fascia Lower Support Replacement (Impala) (Front Bumper Fascia Lower Support Replacement)Front Bumper Fascia Lower Support Replacement (Monte Carlo) (Front Bumper Fascia Lower Support Replacement) in Bumpers.
6. Lower the vehicle.