Finding A Station

AM-FM: Press this button in order to switch between AM, FM1 and FM2. The display will show your selection.

TUNE: Turn this knob in order to choose the radio station.

SEEK: Press the right arrow in order to tune to the next higher station and stay there. Press the left arrow in order to tune to the next lower station and stay there.

SCAN: Press and hold one of the SEEK arrows for 2 seconds until you hear a beep. Use SCAN in order to listen to stations for a few seconds. The radio will go to a station, stop for a few seconds, then go to the next station. Press one of the SEEK arrows again in order to stop the scanning.

PRESET SCAN: Press and hold one of the SEEK arrows for more than four seconds until you hear a double beep. Use PRESET SCAN in order to listen to each of your preset stations for a few seconds. The radio will go to the first preset station stored on your push-button, stop for a few seconds, then go to the next preset station. Press one of the SEEK arrows again in order to stop scanning presets. The channel number (P1-P6) will appear momentarily just before the frequency is displayed.

Push-buttons: The 6 numbered push-buttons let you return to your favorite station. You can set a maximum of 18 stations (6AM, 6 FM1 and 6 FM2), using the following procedure:
1. Turn ON the radio.
2. Press AM-FM in order to select the band.
3. Tune in the desired station.
4. Press and hold one of the six numbered buttons until you hear a beep. Whenever you press that numbered button, the station you set will return.
5. Repeat the steps for each push-button.