Setting the Tone

BAS: Press and release AUDIO until BAS appears on the display. Then press and hold the up arrow in order to increase bass. B and a positive number will appear on the display. Press and hold the down arrow in order to decrease bass B and a negative number will appear on the display. B and a zero will appear on the display when the bass level is set to the middle position. Release the up or down arrow when you find the bass level you want or when the maximum or minimum level is reached.

TRE: Press and release AUDIO until TRE appears on the display. Then press and hold the up arrow in order to increase treble. T and a positive number will appear on the display. Press and hold the down arrow in order to decrease treble. T and a negative number will appear on the display. T and a zero will appear on the display when the treble level is set to the middle position. Release the up or down arrow when you find the treble level you want or when the maximum or minimum level is reached. If a station is weak or noisy, you may want to decrease the treble.

In order to set the BAS or TRE to the middle position, select the desired tone control. then press and hold AUDIO for more than 2 seconds until you hear a beep. B and a zero or T and a zero will appear on the display. In order to set all of the tone controls and speaker controls to the middle position, end out of radio mode. Then Press and hold AUDIO for more than 2 seconds until you hear a beep. CEN will appear on the display.