Finding A Station

AM-FM: Press this button in order to switch between AM, FM1 and FM2. The display will show your selection.

TUNE: Turn this knob in order to choose the radio station.

SEEK: Press the right arrow in order to tune to the next higher station and the left arrow in order to tune to the next lower station and stay there.

SCAN: Press and hold one of the SEEK arrows for two seconds until you hear a beep. Use SCAN in order to listen to stations for a few seconds. The radio will go to a station, stop for a few seconds, then go to the next station. Press one of the SEEK arrows again in order to stop the scanning.

PRESET SCAN: Press and hold one of the SEEK arrows for more than four seconds until you hear a double beep. Use PRESET SCAN in order to listen to each of your preset stations for a few seconds. The radio will go to the first preset station stored on your push-button, stop for a few seconds, then go to the next preset station. Press one of the SEEK arrows again in order to stop scanning presets. The channel number (P1-P6) will appear momentarily just before the frequency is displayed.

Push-buttons: The 6 numbered push-buttons let you return to your favorite station. You can set up to 18 stations (6 AM, 6 FM1 and 6 FM2), using the following procedure:
1. Turn ON the radio.
2. Press AM-FM in order to select the band.
3. Tune in the desired station.
4. Press and hold one of the 6 numbered buttons until you hear a beep. Whenever you press that numbered button, the station you set will return.
5. Repeat the steps for each push-button.