LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2000 >> Cutaway 6.5 F >> Repair and Diagnosis >> External Pages >> Different car >> Section 278 (Supplemental Inflatable Restraint System) >> Removal & Installation >> Sir Coil Assembly >> Removal & Installation

Removal & Installation

WARNING: This page is about a different car, the 2003 Chevrolet Corvette. However, it is still accessible from the selected car via links, so may be relevant.
  1. Before proceeding, see AIR BAG SAFETY PRECAUTIONS . Disable air bag system. See ZONE 3  under DISABLING & ACTIVATING AIR BAG SYSTEM.
  2. Remove driver-side air bag. See AIR BAG MODULES . Remove steering wheel. See STEERING WHEEL . Remove upper and lower steering column covers.
  3. Remove wire harness straps from steering wheel column wire harness. Disconnect SIR coil connectors. Remove retaining ring from steering shaft. See Fig 1. Remove SIR coil.
  4. To install, reverse removal procedure. Tighten steering wheel nut and driver-side air bag module bolts to specification. See TORQUE SPECIFICATIONS . Activate air bag system. See ZONE 3  under DISABLING & ACTIVATING AIR BAG SYSTEM.
Fig 1: Identifying SIR Coil Assembly
G99B00357Courtesy of GENERAL MOTORS CORP.
scientia non olet · About LEMON Manuals