4.3L "C" & "K" Series: Removal
WARNING: This page does not describe the selected car, but rather 55 other vehicles, including the 1999 Oldsmobile Bravada, 1999 GMC Yukon, 1999 GMC Suburban, 1999 GMC Sonoma, and 1999 GMC Sierra. However, it is still accessible from the selected car via links, so may be relevant.
- Disconnect the battery negative cable. Remove the oil level indicator. Raise the vehicle.
- Remove the engine oil and the engine oil filter. Remove the oil filter adapter. Refer to OIL FILTER ADAPTER .
- Remove the starter motor. Remove the transmission cover.
- Remove the oil cooler pipes and the retainer from the side of the engine.
- Remove the transmission. Refer to REMOVAL & INSTALLATION ("C" & "K" SERIES) .
- Remove the engine flywheel.
- Remove the access plugs for the oil pan rear nuts. Remove the oil pan nuts and bolts.
- Remove the ten oil pan bolts.
- Remove the two nuts at the crankshaft rear oil seal.
- Remove the transmission to oil pan bolts.
- Remove the engine oil pan and the oil pan gasket.
Clean all sealing surfaces.