Test 5: Fuel Gauge Always Indicates Full: Gasoline
NOTE:
Before performing this test procedure, check for Diagnostic Trouble Codes (DTC). If DTCs P0641, P0642 and/or P0643 exist, perform appropriate repair procedure. See appropriate SELF-DIAGNOSTICS article in ENGINE PERFORMANCE.
- Turn ignition off. Disconnect instrument cluster harness connector. Disconnect Vehicle Control Module (VCM) Blue harness connector C1. Check continuity of Purple wire between terminal No. 9 at VCM harness connector C1 and terminal No. 16 at instrument cluster harness connector. See Figure and Fig 1 . If continuity exists, go to step 3. If continuity does not exist, go to next step.
- Repair open in Purple wire between VCM and instrument cluster.
- Replace instrument cluster.