LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2000 >> Astro Van Passenger, AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 485 (Disc Brakes & Drum Brakes) >> Removal & Installation >> Park Brake Shoe - Rear Disc >> Removal

Park Brake Shoe - Rear Disc: Removal

WARNING: This page is about a different car, the 2003 Pontiac Aztek and 2003 Buick Rendezvous. However, it is still accessible from the selected car via links, so may be relevant.
  1. Raise and support the vehicle.
  2. Remove the rear tire and wheel assemblies.
  3. Relieve the park brake system tension at the equalizer assembly.
  4. Remove the rear caliper bracket. See BRAKE CALIPER BRACKET .
  5. Remove the rear rotor. See BRAKE ROTOR .
  6. Disconnect and remove the rear park brake cable from the bracket at the rear wheel. See PARK BRAKE CABLE .
  7. Disconnect the park brake cable return spring from the park brake actuator and bracket at the rear wheel.
  8. Remove the rear hub. See appropriate REAR article in SUSPENSION. The rear hub, backing plate, park brake cable bracket, and park brake actuator will be removed as an assembly.
  9. Remove the 2 retainers and the park brake cable bracket from the park brake actuator. Position the rear hub aside.
  10. Remove the park brake shoe and actuator from the backing plate.
  11. Separate the park brake shoe from the actuator.
scientia non olet · About LEMON Manuals