LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2000 >> Astro Van Passenger, AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 485 (Disc Brakes & Drum Brakes) >> Removal & Installation >> Park Brake Shoe - Rear Disc >> Installation

Park Brake Shoe - Rear Disc: Installation

WARNING: This page is about a different car, the 2003 Pontiac Aztek and 2003 Buick Rendezvous. However, it is still accessible from the selected car via links, so may be relevant.
  1. Assemble the park brake shoe to the actuator.
  2. Install the park brake shoe and actuator onto the backing plate.
  3. Position the park brake shoe, actuator, and backing plate over the rear hub.
  4. Install the park brake cable bracket and the 2 retainers.
  5. Install the rear hub. See appropriate REAR article in SUSPENSION. The rear hub, backing plate, park brake cable bracket, and park brake actuator will be installed as an assembly.
  6. Connect the rear park brake cable to the bracket at the rear wheel. See PARK BRAKE CABLE .
  7. Connect the park brake cable return spring to the park brake actuator and bracket at the rear wheel.
  8. Install the rear rotor. See BRAKE ROTOR .
  9. Install the rear caliper bracket. See BRAKE CALIPER BRACKET .
  10. Install the rear tire and wheel assemblies.
  11. Adjust the park brake. See appropriate procedure under PARK BRAKE  in ADJUSTMENTS & INSPECTION.
  12. Lower the vehicle.
scientia non olet · About LEMON Manuals