LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2000 >> Astro Van Passenger, AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 485 (Disc Brakes & Drum Brakes) >> Removal & Installation >> Brake Caliper Bracket >> Removal (Rear)

Removal (Rear)

WARNING: This page is about a different car, the 2003 Pontiac Aztek and 2003 Buick Rendezvous. However, it is still accessible from the selected car via links, so may be relevant.
  1. Inspect the fluid level in the brake master cylinder reservoir.
  2. If the brake fluid level is midway between the maximum-full point and the minimum allowable level, then no brake fluid needs to be removed from the reservoir before proceeding. If the brake fluid level is higher than midway between the maximum-full point and the minimum allowable level, then remove brake fluid to the midway point before proceeding.
  3. Raise and support the vehicle.
  4. Remove the tire and wheel.
  5. Remove the brake caliper. See BRAKE CALIPER .
  6. Remove the brake pads from the brake caliper bracket.
  7. Remove the brake pad retainers from the brake caliper bracket.
  8. Remove the brake caliper bracket bolts.
  9. Remove the brake caliper bracket.
  10. Remove the brake caliper bolt boots from the brake caliper bracket.
  11. Remove the brake caliper bolt bushings from the brake caliper bracket.
  12. Inspect and replace the brake caliper bracket if cracks or deformation damage exists.
  13. Use a wire brush in order to clean away any rust and debris from the brake caliper bracket where the brake pads contact the brake caliper bracket.
scientia non olet · About LEMON Manuals