LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2000 >> Astro Van Passenger, AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 1191 (Engine Mechanical (Repair Instructions 5 Of 5) - 3.6L (Ly7)) >> Repair Instructions (Off-Vehicle Repair Instructions - Part 4) >> Drive Belt Idler Pulley Installation

Drive Belt Idler Pulley Installation

WARNING: This page is about a different car, the 2004 Buick Rendezvous. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Identifying Drive Belt Idler Pulley
    GM1395910Courtesy of GENERAL MOTORS CORP.
  1. Place the drive belt idler pulley and bolt in position through the generator mounting hole and into the engine front cover.
    2. NOTE: Refer to Fastener Notice in Cautions and Notices.
  2. Install the drive belt idler pulley bolt.

    Tighten:  Tighten the drive belt idler pulley bolt to 50 N.m (37 lb ft).

  3. Tighten the generator bolts.

    Tighten:  Tighten the generator bolts to 50 N.m (37 lb ft).

scientia non olet · About LEMON Manuals