LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2000 >> Astro Van Passenger, AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 1190 (Engine Mechanical (Repair Instructions 4 Of 5) - 3.6L (Ly7)) >> Repair Instructions (Off-Vehicle Repair Instructions - Part 3) >> Crankshaft and Bearings Installation >> Crankshaft Installation Procedure

Crankshaft Installation Procedure

WARNING: This page is about a different car, the 2004 Buick Rendezvous. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: View Of Crankshaft Sprocket Drive Pin
    GM902741Courtesy of GENERAL MOTORS CORP.
    NOTE: The crankshaft sprocket drive pin must be set to the proper depth. Installing the crankshaft sprocket drive pin too deep can lead to damage to the crankshaft sprocket and extensive engine damage.
  1. If removed, install the crankshaft sprocket drive pin. Lightly tap the pin in place with a small soft face, bronze/plastic, hammer until it bottoms in the hole.
    2. Fig 2: View Of Crankshaft
    GM902743Courtesy of GENERAL MOTORS CORP.
  2. Gently lower the crankshaft into position in the cylinder block.
scientia non olet · About LEMON Manuals