Test 10: Driver Information Center Temperature Display Always Reads SC
NOTE:
Outside ambient air temperature sensor is also referred to as ambient air temperature sensor.
- Turn ignition off. Disconnect ambient air temperature sensor 2-pin connector and observe Diver Information Center (DIC) display. If display indicates SC, go to next step. If display does not indicate SC, go to step 3 .
- Repair short to ground in Light Green/Black wire between ambient air temperature sensor, compass/temperature display module and convenience center. See OVERHEAD CONSOLE - ASTRO & SAFARI article.
- Replace ambient air temperature sensor. See AMBIENT AIR TEMPERATURE SENSOR under REMOVAL & INSTALLATION. After repairs, go to next step.
- Connect all disconnected components. Check system for proper operation. If system operates properly, test is complete. If system does not operate properly, go to step 1 .