LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 1999 >> Venture Base, Van Cargo Extended >> Repair and Diagnosis >> External Pages >> Different car >> Section 2 (Disc Brakes & Drum Brakes) >> Removal & Installation >> Rear Axle Hub Bearings & Oil Seal (Full-Floating Axle) >> Installation (11"Axle With Disc Brakes)

Installation (11"Axle With Disc Brakes)

WARNING: This page does not describe the selected car, but rather 30 other vehicles, including the 1998 Pontiac Trans Sport, 1998 Oldsmobile Silhouette, 1998 Oldsmobile Bravada, 1998 GMC Yukon, and 1998 GMC Suburban. However, it is still accessible from the selected car via links, so may be relevant.
  1. Clean and pack bearings with Wheel Bearing Lubricant (1051344). Using handle and Bearing Race Installer (J-8608), drive outer wheel bearing race into hub from inboard side of hub (ensure chamfered edge of bearing race installer is facing upward so that it does not contact bearing race).
  2. Install retaining ring on inboard side of outer bearing race. Turn hub and rotor assembly inboard side down. Using Outer Bearing Race Remover/Installer (J-24426), seat outer bearing race against retaining ring.
  3. Using Inner Bearing Race Remover/Installer (J-24427), drive inner bearing race into hub from inboard side of hub. Install inner bearing. Install new oil seal using Axle Shaft Seal Installer (J-24428).
  4. To complete installation, reverse removal procedure. To adjust wheel bearings, follow rear brake rotor installation procedure.
scientia non olet · About LEMON Manuals