LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 1999 >> Venture Base, Van Cargo Extended >> Repair and Diagnosis >> External Pages >> Different car >> Section 2 (Disc Brakes & Drum Brakes) >> Removal & Installation >> Rear Axle Bearing & Oil Seal (Semi-Floating Axle) >> Removal (Astro, Safari, & "S" & "T" Series)

Removal (Astro, Safari, & "S" & "T" Series)

WARNING: This page does not describe the selected car, but rather 30 other vehicles, including the 1998 Pontiac Trans Sport, 1998 Oldsmobile Silhouette, 1998 Oldsmobile Bravada, 1998 GMC Yukon, and 1998 GMC Suburban. However, it is still accessible from the selected car via links, so may be relevant.
  1. Raise and support vehicle. Remove wheels and brake drums. Loosen differential cover plate and drain lubricant from axle. Remove cover plate.
  2. Remove pinion shaft lock bolt. See Fig 1 and Figure . Remove pinion shaft. Push axle shaft toward center of vehicle and remove "C" lock from end of axle shaft. Remove axle shaft.
  3. Pry seal from axle housing. Using Slide Hammer (J-2619-01) and Axle Bearing Puller (J-22813-01), remove bearing from axle housing.
Fig 1: Locating "C" Lock & Pinion Shaft Lock Bolt (Astro, Safari, & "S" & "T" Series Shown; Others Similar)
G90A13573Courtesy of GENERAL MOTORS CORP.
scientia non olet · About LEMON Manuals