LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 1999 >> Venture Base, Van Cargo Extended >> Repair and Diagnosis >> External Pages >> Different car >> Section 2 (Disc Brakes & Drum Brakes) >> Removal & Installation >> Height-Sensing Proportioning Valve >> Removal & Installation ("C" & "K" Series)

Removal & Installation ("C" & "K" Series)

WARNING: This page does not describe the selected car, but rather 30 other vehicles, including the 1998 Pontiac Trans Sport, 1998 Oldsmobile Silhouette, 1998 Oldsmobile Bravada, 1998 GMC Yukon, and 1998 GMC Suburban. However, it is still accessible from the selected car via links, so may be relevant.
  1. Raise vehicle by frame, allowing rear axle to hang free. Remove bracket that covers valve. Remove nut and lever from valve shaft. See Figure. Clean area around brake line fittings at valve. Disconnect brake lines from valve. Remove valve-to-frame bolts and valve.
  2. To install, reverse removal procedure, ensuring rear axle is hanging free and valve is securely bolted to frame when lever is attached to valve (this ensures correct valve adjustment). See HEIGHT-SENSING PROPORTIONING VALVE  under ADJUSTMENTS. Bleed brake system. See MANUAL BLEEDING  or PRESSURE BLEEDING  under BLEEDING BRAKE SYSTEM.
scientia non olet · About LEMON Manuals