LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 1999 >> Forward Control P30, 7.4 J >> Repair and Diagnosis >> External Pages >> Different car >> Section 2 (Disc Brakes & Drum Brakes) >> Removal & Installation >> Rear Axle Hub Bearings & Oil Seal (Full-Floating Axle) >> Removal (10 1/2" & 11" Axle With Drum Brakes)

Removal (10 1/2" & 11" Axle With Drum Brakes)

WARNING: This page does not describe the selected car, but rather 30 other vehicles, including the 1998 Pontiac Trans Sport, 1998 Oldsmobile Silhouette, 1998 Oldsmobile Bravada, 1998 GMC Yukon, and 1998 GMC Suburban. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove rear hub and drum assembly. See REAR BRAKE DRUM . Using a long drift and hammer, drive out inner bearing race, inner bearing and oil seal from outboard to inboard side of hub. See Figure.
  2. Remove retaining ring from inside of hub, inboard of outer bearing. Using Handle (J-8092) and Outer Bearing Race Remover/Installer (J-24426), drive out outer bearing race from outboard to inboard side of hub.
scientia non olet · About LEMON Manuals