LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 1999 >> Forward Control P30, 7.4 J >> Repair and Diagnosis >> External Pages >> Different car >> Section 2 (Disc Brakes & Drum Brakes) >> Removal & Installation >> Rear Axle Bearing & Oil Seal (Semi-Floating Axle) >> Installation (Astro, Safari, & "S" & "T" Series)

Installation (Astro, Safari, & "S" & "T" Series)

WARNING: This page does not describe the selected car, but rather 30 other vehicles, including the 1998 Pontiac Trans Sport, 1998 Oldsmobile Silhouette, 1998 Oldsmobile Bravada, 1998 GMC Yukon, and 1998 GMC Suburban. However, it is still accessible from the selected car via links, so may be relevant.
  1. Lubricate bearing with gear lubricant. Using Handle (J-8092) and Bearing Installer (J-23765), install bearing in axle housing until bearing installer bottoms against shoulder of axle housing.
  2. Using Seal Installer (J-23771), install seal until even with surface of axle housing. Lubricate seal lips with gear lubricant. Install axle shaft and "C" lock. See Figure and Fig 1 . Pull axle shaft outward to ensure "C" lock seats in side gear.
  3. Install pinion shaft. Install NEW pinion shaft lock bolt. Tighten lock bolt to 25 ft. lbs. (34 N.m). Install differential cover and new gasket. Fill drive axle with gear lubricant.
Fig 1: Removing & Installing "C" Lock & Pinion Shaft On Locking Differential (Typical)
G95E27106Courtesy of GENERAL MOTORS CORP.
scientia non olet · About LEMON Manuals