Retrieving Codes
CAUTION:
Check system operation prior to retrieving codes. See FUNCTION TEST .
NOTE:
Diagnostic Trouble Codes (DTC) are displayed on 3 transfer case shift select buttons. When proper conditions are met, select buttons will blink to indicate DTC from "1" to "4".
- Turn ignition off for at least 6 seconds. Locate DLC near right side of steering column. Install jumper wire between diagnostic pigtail (Orange wire at DLC, terminal No. 13) and ground.
- Turn ignition on (engine off). Observe shift select buttons. If all shift select buttons blink once at same time then stop, no DTCs are stored. If only one code is stored, that code will blink repeatedly, with a 3 second delay between sequences. If more than one code is present, next code will flash after a 3 second delay, then sequence will repeat. Count number of blinks for each code. See Fig 1.
- Write down all DTCs. After RETRIEVING CODES clear TCCM memory and repeat procedure. See CLEARING CODES . If DTCs return, perform appropriate DTC test. See DIAGNOSTIC TESTS .