LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 1999 >> Blazer 4D Utility, 4WD, Automatic >> Repair and Diagnosis >> Suspension >> FRONT SUSPENSION - 4WD Torsion Bar >> Removal & Installation >> Wheel Hub & Bearings >> Removal

Wheel Hub & Bearings: Removal

  1. Raise and support vehicle. Unload tension on torsion bar. Remove wheel and tire assembly. Install Axle Shaft Boot Seal Protector (J-28712) to axle shaft boot to protect drive axle during repair. Depress brake caliper piston, detach brake caliper, and wire aside. Remove brake rotor. See Figure. Remove axle shaft nut cotter pin, retainer, axle shaft nut and washer. Pull hub and bearing assembly off axle shaft.
    2. NOTE: Darkened areas on bearing assembly are caused by heat treatment process and DO NOT indicate a need for replacement.
  2. Inspect steering knuckle grease seal for cuts, distortion and wear. Inspect steering knuckle, hub and bearing for damage. Replace as necessary. If wheel hub stud must be replaced, use Wheel Stud Remover (J-6627-A).
scientia non olet · About LEMON Manuals