LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 1999 >> Blazer 4D Utility, 4WD, Automatic >> Repair and Diagnosis >> Suspension >> FRONT SUSPENSION - 4WD Torsion Bar >> Removal & Installation >> Steering Knuckle >> Installation

Steering Knuckle: Installation

  1. Using hammer and Steering Knuckle Seal Installer (J-28574), install NEW steering knuckle grease seal into steering knuckle. Install spacer (if equipped). Install steering knuckle onto upper and lower ball joint studs.
    2. CAUTION: When installing upper and lower ball joint stud nuts, tighten nut to align cotter pin hole. DO NOT tighten ball joint stud nuts more than an additional 1/6 turn to align cotter pin hole. Complete tightening of ball joint stud nuts with vehicle at proper ride height.
  2. Install ball joint stud nuts and cotter pins. Install drive axle (if removed). Install tie rod end onto steering knuckle. Install tie rod end stud nut and cotter pin. Install splash shield. Install hub and bearing assembly onto axle shaft and into steering knuckle.
  3. To complete installation, reverse removal procedure. Tighten bolts and nuts to specification. See TORQUE SPECIFICATIONS  table. Lower vehicle. Check wheel alignment and adjust ride height. See SPECIFICATIONS & PROCEDURES - TRUCKS article in WHEEL ALIGNMENT.
Fig 1: Unloading Torsion Bar Tension
G95E27304Courtesy of GENERAL MOTORS CORP.
Fig 2: Separating Ball Joint From Steering Knuckle
G95F27305Courtesy of GENERAL MOTORS CORP.
scientia non olet · About LEMON Manuals