Lower Ball Joint: Installation

CAUTION: When installing lower ball joint stud nut, tighten nut to align cotter pin hole. DO NOT tighten ball joint stud nut more than an additional 1/6 turn to align cotter pin hole. Complete tightening of lower ball joint stud nut with vehicle at proper riding height specification.

To install, reverse removal procedure. Use NEW nuts and bolts to install ball joints to lower control arm. Lubricate NEW ball joint. Tighten bolts and nuts to specification. See TORQUE SPECIFICATIONS table. Lower vehicle. Check wheel alignment and adjust ride height. See SPECIFICATIONS & PROCEDURES - TRUCKS article in WHEEL ALIGNMENT.