Ambient Temperature Sensor / Switch HVAC: Service and Repair

REMOVAL PROCEDURE
The radiator support flange (1) mounts the ambient outside air temperature sensor near the radiator baffle A 2-wire weather pack electrical connector attaches the ambient outside air temperature sensor to the forward lamp harness (2). In order to service the ambient outside air temperature sensor, perform the following steps:
1. Turn the ignition OFF.
2. Open the hood.
3. Disconnect the electrical connector from the outside ambient air temperature sensor.
4. Remove the outside ambient air temperature sensor to radiator support bolt.
5. Remove the outside ambient air temperature sensor from the vehicle.

INSTALLATION PROCEDURE
1. Install the outside ambient air temperature sensor to the vehicle.

NOTICE: Refer to Fastener Notice in Cautions and Notices.

2. Install the outside ambient air temperature sensor to radiator support bolt.

Tighten
Tighten the bolt to 2 N.m (18 lb in).

3. Connect the electrical connector to the outside ambient air temperature sensor.