D Pillar

Tools Required
J 29843-9

Description:

1. Unsnap the cover (2) from the upper seat belt anchor.
2. Use the J 29843-9 in order to remove the bolt (1) securing the upper seat belt anchor from the D-pillar (3).
3. Remove the upper seat belt anchor from the D-pillar (3).
4. Raise the carpeting in order to expose the lower seat belt anchor bolt (5).
5. Use the J29843-9 in order to remove the bolt (5) securing the lower seat belt anchor (4) from the floor.

Description:

6. Unsnap the plastic trim cover from the D-pillar (3) trim panel. Slide the belt webbing through the slot.
7. Remove the driver's side rear quarter trim with RPO-C34, rear A/C only. Refer to Rear Quarter Trim in Rear Quarters.
8. Use the J 29843-9 in order to remove the bolt securing the retractor from the D-pillar.
9. Remove the retractor side seat belt from the vehicle.
10. Remove the retractor from the vehicle.