Accelerator Controls Cable Bracket Replacement

REMOVE OR DISCONNECT
1. Accelerator cable cross slug from throttle body slot.
2. Depress the tangs and remove the accelerator cable from accelerator cable bracket.
3. Nuts and bolts holding the accelerator cable bracket to the throttle body.
4. Accelerator cable bracket.

INSTALL OR CONNECT
1. Accelerator cable bracket to throttle body.
2. Accelerator cable bracket nuts and bolts.
3. Tighten the nuts and bolts in sequence (2,1,3) to 12 N.m (106 lb in).
4. Accelerator cable into accelerator cable bracket.
5. Accelerator cable cross slug into the throttle body slots.