LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 1998 >> Venture V6-3.4L VIN E >> Repair and Diagnosis >> Brakes and Traction Control >> Sensors and Switches - Brakes and Traction Control >> Wheel Speed Sensor >> Service and Repair >> Wheel Speed Sensor Jumper Harness Replacement (Left Front)

Wheel Speed Sensor Jumper Harness Replacement (Left Front)

REMOVAL PROCEDURE
1. Raise and support the vehicle on a suitable hoist.
2. Remove the connector from the left front wheel sensor.





3. Remove the harness (4) from the control arm retaining clips (3).
4. Remove the harness (4) from the splash shield retaining clips (5).
5. Remove the left front wheel speed sensor jumper harness to ABS harness connector (8).
6. Remove the left front wheel speed sensor jumper harness (4).

INSTALLATION PROCEDURE





1. Install the left front wheel speed sensor jumper harness to ABS harness connector (8).
2. Install the harness (4) to splash shield retaining clips (5).
3. Install the harness (4) to control arm retaining clips (3).
4. Install the connector to wheel speed sensor.
5. Lower the vehicle.
scientia non olet · About LEMON Manuals