Removing the Customer's Code

Important: Either the customer's code or the factory backup code may be used in order to remove the customer's code.

1. Hold in the pushbuttons 1 and 4 for about 6 seconds until the display changes to SEC, with the radio in the OFF position.

IMPORTANT: The theft deterrent is already deactivated and no code is stored if the display changes to a series of dashes.

2. Press the HR button.
3. Set the first 2 digits (0-19) of the code with the HR button.
4. Set the next 2 digits (0-99) of the code with the MN/MIN button.
5. Press AM-FM button in order to enter the code.
6. The theft deterrent is deactivated. A series of dashes will display, then the clock will display.