Interior Lighting Modes

Perform the following procedure to change the interior lighting mode:
1. Turn off the I/P dimmer switch.
2. Turn the ignition switch to the LOCK position.
3. Remove the BCM PRGRM fuse.
4. Turn the ignition switch to the ACC position.
^ The BCM sounds the chime a number of times equivalent to the BCM type installed on the vehicle.
^ Now the BCM has entered the feature customization mode.
^ To change the interior lighting mode, cycle the I/P dimmer switch from off to DOME, back to off.
^ The BCM sounds the chime a number of times equivalent to the lighting mode.

The lighting modes are as follows:
^ Mode 1: Exit illumination and delayed illumination are disabled.
^ Mode 2: Delay illumination is enabled.
^ Mode 3: Exit illumination is enabled.
^ Mode 4: Exit illumination and delayed illumination are enabled.