LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 1998 >> Venture Base, Van Cargo Extended >> Repair and Diagnosis >> Brakes >> Mechanical - Hydraulic >> Disc Brakes & Drum Brakes >> Removal & Installation >> Rear Caliper (Disc Brakes - C & K Series) >> Removal

Rear Caliper (Disc Brakes - C & K Series): Removal

  1. Remove two-thirds of the brake fluid from master cylinder. Raise vehicle and support with safety stands. Mark relationship of wheel to hub. Remove wheel.
  2. Position a C-clamp and tighten until piston bottoms in bore. SeeFigure. Remove C-clamp. Remove brake hose.
  3. Remove bolt. Support key and spring. Use a brass punch and a hammer to drive the support key out. See Figure. Remove caliper assembly.
scientia non olet · About LEMON Manuals