LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 1998 >> Monte Carlo LS >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 4 (Engine Controls - Removal & Installation, Overhaul - 3.4L) >> Ignition System >> Ignition Control Module (C(3)I) >> Removal & Installation

Removal & Installation

WARNING: This page is about a different variant/trim than selected.
  1. Disconnect negative battery cable. Disconnect 14-way connector at ignition control module. Disconnect spark plug wires from coil pack. Remove 6 screws retaining coils to ignition control module. Remove ignition coils from module.
  2. Remove screws and washers securing ignition control module to bracket. Remove ignition control module. To install, reverse removal procedure. Tighten retaining screws to specification. See TORQUE SPECIFICATIONS .
scientia non olet · About LEMON Manuals