LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 1998 >> Monte Carlo LS >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 4 (Engine Controls - Removal & Installation, Overhaul - 3.4L) >> Ignition System >> Camshaft Position Sensor >> Removal & Installation

Removal & Installation

WARNING: This page is about a different variant/trim than selected.

Disconnect negative battery cable. Disconnect electrical connector from camshaft position sensor. Remove camshaft position sensor mounting bolt and remove camshaft position sensor. To install, reverse removal procedure. Tighten camshaft position sensor bolt to specification. See TORQUE SPECIFICATIONS .

scientia non olet · About LEMON Manuals