Idle Air Control (IAC) Valve: Installation

WARNING: This page is about a different variant/trim than selected.

Inspect gasket or "O" ring for damage. Replace as necessary. Check extended distance of IAC pintle before installing. Damage will occur if measurement is incorrect. Distance must not exceed 1.100" (28 mm). Measurement should be taken from valve housing flange to end of pintle cone.
To retract NEW IAC valve pintle, slowly exert finger pressure on valve. Install NEW "O" ring or gasket on valve. Coat "O" ring with clean engine oil. Install IAC valve. Tighten IAC valve to specification. See TORQUE SPECIFICATIONS . Reconnect electrical connector to IAC valve. To reset IAC valve, refer to ADJUSTMENTS - 3.8L article.