Circuit Description

WARNING: This page is about a different variant/trim than selected.

The Output Driver Module (ODM) is used by the PCM to turn on many of the current-driven devices that are needed to control various engine and transaxle functions. Each ODM is capable of controlling up to 7 separate outputs by applying ground to the device which the PCM is commanding on. ODM have the capability of diagnosing each output circuit individually.

Conditions required to set DTC are:

Ignition is on.
Improper voltage level detected on fuel pump speed control Pulse Width Modulated (PWM) circuit.
Conditions present for at least 30 seconds.