Circuit Description

WARNING: This page is about a different variant/trim than selected.

Output Driver Modules (ODM) are used by PCM to turn on current-driven devices needed to control various engine and transaxle functions. Each ODM can control up to 7 outputs, including boost control solenoid, by supplying ground to device PCM is commanding on. ODMs can diagnose each circuit individually. If ODM "A" output 5 (boost control solenoid driver circuit) detects an improper voltage level, DTC is set.

Conditions for setting DTC:

Ignition is on.
An improper voltage level has been detected on boost control solenoid driver circuit.
Conditions present for at least 30 seconds.