Circuit Description

WARNING: This page is about a different variant/trim than selected.

Vehicle operation is disabled if incorrect key or starting procedure is used. Theft deterrent module enables crank circuit to starter and sends a signal to PCM if correct key is being used. If proper signal does not reach PCM fuel enable signal circuit, PCM will not pulse injectors on, disabling vehicle, even if crank circuit is by-passed. Signal should be 40-60 Hz and is measured using DVOM in Hertz scale.

Conditions required to set DTC are:

Engine running.
PCM detects incorrect signal on Theft Deterrent System (TDS) fuel enable circuit.
Conditions are present for more than 2 seconds.