Circuit Description

WARNING: This page is about a different variant/trim than selected.

Ignition Control Module (ICM) sends signals that PCM requires for fuel control and spark advance calculations. At start of engine crank, ICM controls spark advance (by-pass mode). When second 3X signal is recognized by PCM, it applies 5 volts to by-pass circuit, commanding ICM to switch Ignition Control (IC) of spark advance to PCM (IC mode). A short in IC circuit, or an open or short ground in by-pass circuit will set DTC 1361.

Condition required to set DTC is:

PCM monitors IC pulses during crank while by-pass mode spark advance is commanded.